Gloss level @ 60˚
Gloss: 95 | Matt: 25
@30˚ C and 60% RH
Above 15˚ C
10 – 15 minutes
8 – 12 Hours
*Recoat and drying period may vary under different conditions
80 – 100 Sq ft / L / Coat
*Actual coverage may vary based on the type of wood used and the application methodology.
Opulence Basecoat Sealer
|Application Method-Basecoat Sealer||Thinner||No.of coats||Re-coating Time||Sanding*|
Air Assisted Airless, HVLP
|20-30% PU Thinner D-63||2||8-12 Hours (not exceed 72 hrs)||320 / 400|
Sand between the coats with 320 emery paper to denib the wood hair. Dust off with dry cloth. This removes upstanding wood fiber ends and dust particles which could draw moisture in behind the film and shorten the life of the coating.
|Application Method-Topcoat Glossy / Matt||Thinner||No.of coats||Re-coating Time||Sanding|
|Conventional, Airless, Air Assisted Airless, HVLP||20-30% NC Thinner D-63||1 – 2 coats||8-12 Hours (not exceed 72 hrs)||400 / 600|
HVLP GUNS – 1.2 mm – 1.4mm tip 8-10 psi (output) CONVENTIONAL GUNS – 1.2mm – 1.6mm tip 40-50 psi
FILLER: If required use Sheenlac NC or WB Timber filler. Remove the excess using 220 grit Emery paper and wipe-out the dust with dry cloth.
DURABILITY: It forms a tough yet flexible film which resists cracking even at curved edges. Further its special chemistry imparts it good heat, stain and chemical resistance properties.
SUPERIOR GLOSS RETENTION: Opulence Interior Forms a clear non yellowing coat on your wooden interiors which accentuates their beauty for a long duration.
RESISTANCE: Opulence has high gloss, stain and heat resistance when compared to conventional wood finishes.
FILM FLEXIBILITY: Opulence forms and extremely flexible film on the surface of wood which resists cracking even on the curved edges.
SURFACE PREPARATION: All wood surfaces must be clean, firm and dry. Remove any oil, grease, mortar droppings, etc
NEW WOOD: Sand in the direction of the grain, to a smooth finish with 150 followed by 220 grit paper. Remove dust with a damp cloth
PREVIOUSLY VARNISHED WOOD IN GOOD CONDITION: Sand to obtain a smooth surface using 150 grit emery paper. Remove all sanding dust using a vacuum or cloth dampened with mineral spirits.
PREVIOUSLY VARNISHED WOOD IN POOR CONDITION: Strip completely by deep sanding or by using Sheenlac Paint Remover. Rinse thoroughly with clean water. Deep sand to until there is no evidence of any residue. Remove dust with a damp cloth.
1. Always keep paint out of reach of children.
2. Ensure good ventilation during application and drying.
3. If accidental contact with skin should occur, wash immediately with soap and water.
4. Take care to avoid contact with the eyes. In case of contact, immediately rinse the eyes with plenty of water and seek medical attention.
5. Harmful if swallowed. Seek medical attention and do not induce vomiting.
6. Do not smoke while painting.
7. Flammable. Store in a cool dry place away from heat and sparks.
8. Refer to Material Safety Data Sheet for complete information.
Storage and Transportation:
Do not store or transport the containers under direct sunlight or at elevated temperatures. Store the container in an upright position in order to avoid any leakage or damage
2 Years from the date of manufacturing in original tightly closed containers stored away from direct sunlight and excessive heat.